Craftsman 139.53664SRT2 owner manual Receiver and Remote Control Programming

Receiver and Remote Control Programming

Your garage door opener receiver and remote control have been pre-set at the factory. The door will open when you press the LARGE remote control push button. The code between the remote control and the

receiver changes with each use, randomly accessing over 100 billion new codes.

The 3-function remote control can also activate additional SECURITY-I- garage door openers and/or light controls.

Your SECURITY.I, opener will operate with: several SECURITY+ remote controls (with blue push buttons) utilizing up to 8 functions.

•one SECURITY+ Keyless Entry System (Model 139.53684).

Follow the instructions below to program your opener to match any additional remotes you may purchase. See Accessories on page 38.

To Add A Remote Control

If you have a Premium Control Console:

1.With the doorc/osed, press and hold a remote control push button. See Figure 1.

2.Press and hold the Light button on the door control.

3.Press and hold the door control push button.

4.After the opener light flashes, release all buttons. Test by pressing the remote push button.

If you do not have a Premium Control Console:

1.Press and holdthe selected remote control push button. See Figure 1.

2.Then press and release the SRT (learn) button on the back panel of the opener, Figure 2. The indicator light on the panel will begin to blink and the opener light will flash once.

3.Release the remote push button.

Test by pressing the remote push button.

To Erase All Remote Control Codes

Press and hold the SRT button on the opener panel

until the indicator light turns off (about 6 seconds). All remote control codes are now erased. Then follow

the steps above to re-program each remote control.

1 To comply with FCC rules, adjustment or modifications of this receiver /

and/or transmitter are prohibited, except for changing the code setting or / replacing the battery. THERE ARE NO OTHER USER SERF[CEABLE

PARTS.

injury or death. Do not allow children to operate the door push button(s) or remote control(s).

A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted.

Figure I

Select a remote control push button to operate opener

SECURITY'I"

3-Function
Remote Control	Figure 2
	SECURITY+
	Garage Door Opener

SRT (learn) Indicator RIGHT

Button Light PANEL

To Control the Opener Light (Premium Consoles)

With SECURITY+ remote controls, a push button can be programmed to operate the opener light without opening the door.

1.With the door closed, press and hold the remote button that you want to control the light.

2.Press and hold the Light button on the door control.

3.Press and hold the Lock button on the door control.

4.After the opener light flashes, release all buttons.

Test by pressing the remote push button. The opener light should turn on or off but the door should not move.

33