Assembly Step 5
Attach the Belt Cap Retainer
To attach the belt cap retainer:
Position the belt cap retainer over the opener sprocket so the two holes in cap align with the two holes in mounting plate. Attach with 8x3/8" hex screws provided.
Hardware Shown
Actual Size
Hex Screw
#8x3/8'
Hex Screws
#8x3/8" ,_ - Belt Cap Retainer
_t_=_'_l Opener Sprocket
Plate
You have now finished assembling your garage door opener. Please read the following
warnings before proceeding to the installation section:
IMPORTANT INSTALLATION INSTRUCTIONS
To reduce the risk of severe injury or death to persons:
1.READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.
2.Install only on a properly balanced and lubricated garage door. An improperly balanced door may not reverse and could resuff in severe injury or death. Repairs to cables, spring assemblies and other hardware must be made by a professional service person before installing opener.
3.Disable all locks and remove all ropes connected to the garage door before installing the opener. Ropes connected to a garage door can cause entanglement and death.
4.If possible, install door opener 7 feet or more above floor with the emergency release handle mounted 6 feet above the floor.
5.Do not connect the opener to power source until instructed to do so.
6.Locate the Door Control within sight of the door at a minimum height of 5 feet where small children cannot reach, and away from aU moving parts of the door.
7.Install the User Safety Instruction Label on the wall adjacent to the door control and the Maintenance Instruction Label in a prominent location on the inside of the garage door.
8.Upon completion of the installation, the door must reverse when it comes in contact with a
9.Do not wear watches, rings or loose clothing while installing or servicing an opener. Jewelry or loose clothing can be caught in the mechanism of the garage door or the opener.
11
