CHANGING MOTOR VOLTAGE
MAKE CERTAIN THE DUST COLLECTOR mS
DBCONNECTED FROM THE POWER SOURCE.
The motor supplied with your Dust Collector is a duaU voUtage
operate your machine, the following instructions must be followed,
if you are unsure of electrical connections or codes, contact a certified electrician, All local and state codes
must be followed,
Refer to GROUNDING INSTRUCTION section before proceeding:
1, DBCONNECT THE DUST COLLECTOR FROM THE POWER SOURCE.
2, Remove the switch box cover,
3, The motor has four leads, Reconnect the motor
leads for chosen voltage, as shown in the wire diagram, See figure 19,
4, The START/STOP switch is a double pole switch, No changes are required for 120/240 volt operation,
5, Replace the plug with the correct plug with ground for voltage required, The new plug must meet all local and state electrical codes,
6, Reassemble switch box cover,
ON/OFF SWITCH CmRCUmTBREAKER
1
4
120 VOLT CONNECTION
ON/OFF SWITCH CiRCUiT BREAKER
1
3
4
240 VOLT CONNECTION
EEiE i
Fig. 19
16
