Craftsman 152.213371 Connecting Tool to Power Source, START/STOP Switch, Locking Switch JN

FOROPERATORSAFETY,keepfingersandaHHforeign

objectsoutoftheintakeports.Therotatingfaninside theMowerhousingisaccessibHethroughtheintake portsandishazardousDonotwearHoosecHothingor.

jeweHryMakecertainthateachintakeportwhichisnot. beingusedorattachedto a dustcoHHectionsystemis coveredwithan intakeportcap.

CONNECTING TOOL TO

POWER SOURCE

A separate eHectricaHcircuit shouHd be used for your tooHs.This circuit shouHd not be Hessthan #14 A. W. G.

wire and shouHd be protected with a 15-amp time Hag fuse. Have a qualified eHectrician repair or repHacedam- aged or worn cord immediately. Before connecting the motor to the power Hine,make certain the switch is in the "OFF" position and be sure that the eHectriccurrent is of the same characteristics as stamped on the motor namepHate. AHHHineconnections shouHd make good con- tact. Running on HowvoHtage wiHHdamage the motor.

DO NOT EXPOSE THE DUST COLLECTOR TO RAmN OR OPERATE THE MACHmNE mNDAMP LOCATmONS.

START/STOP SWITCH

Fig. 18

\

The START/STOP switch is Hocated on the side of the motor. To turn the dust coHHector"ON", push the green start button (A). To turn the dust coHHector"OFF", push the red stop button (B). See figure 18.

LOCKING SWITCH JN

THE "OFF" POSiTiON

When the Dust CoHHectoris not in use, the start button can be Hocked so that it cannot be started. Using a padHock (incHuded) through the holies in the side of the start button.

CiRCUiT BREAKER

Your dust coHHectormotor is suppHied with a resettabHe circuit breaker. Htis Hocated on top of the start/stop switch box on the side of the motor. Hfthe motor shuts off or faiHsto start due to an overHoad condition, turn the dust coHHector"OFF," Hetthe motor cooHfor three to five minutes, and push the reset button on the circuit breaker to reset the breaker. The motor can then be turned on again in the usuaHmanner.

15