If the machine is to be inoperative for a period longer than 30 days, prepare for storage as follows.
Battery
1.Charge battery fully. The battery loses some of its charge each day when the unit is not used. NEVER store battery without a full charge. Recharge battery before returning to service or every two months, whichever occurs first.
2.When storing unit for extended periods, disconnect battery cables and remove the battery from the unit.
3.Clean dirt and chaff from cylinder, cylinder head fins, blower housing, rotating screen and muffler.
Engine
Engines, stored over 30 days, need special attention to prevent gum formation in the fuel system or on the carburetor.
1.If fuel tank contains oxygenated or reformulated gasoline, that is gasoline blended with alcohol or ether, run engine until dry.
2.If fuel tank contains gasoline, either run engine till dry or add an additive to the gas. If you are using
| Trouble |
|
| Possible | Cause | |
Excessivevibration | 1. | Bent or damaged blade | ||||
|
| 2. | Bent blade. |
|
| |
Mower | will not | 1. | Engine | speed | low. |
|
discharge grass or | 2. | Speed | selection. |
| ||
leaves | uncut strips |
|
|
|
|
|
|
| 3. | Cutting | height | set too low. | |
|
| 4. | Blades | short or dull. |
| |
Broken | Belt | 1. | Sudden | stop or shock | load to belt | |
|
| 2. | incorrect belt | used |
| |
|
| 3. | Belt engaged | abruptly |
| |
|
| 4. | Defective or damaged | belt | ||
additive, run the engine for several minutes to circulate the additive through the carburetor.
3.Change oil on a warm engine.
4.Remove spark plug and pour about one ounce of engine oil into cylinder. Replace the spark plug and crank engine slowly to distribute the oil.
5.Clean engine of debris, chaff or grass clippings.
6.Store engine and riding mower in a clean, dry area far away from stove, furnace, water heater or similar appliances using a pilot light or any other sparking device.
Riding Mower
1.Clean the engine and the entire unit thoroughly.
2.Lubricate all pivot points. Wipe the entire machine with an oiled rag to protect the surfaces.
3.Transport the mower with fuel tank empty. Store unit in a clean, dry area. Do not store next to corrosive materials, such as fertilizer.
4.When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rustproof the equipment. Using a light oil or silicone, coat the equipment, especially any chains, springs, bearings and cables.
Remedy
1.Stop engine immediately. Check all pulleys, blade adapters, keys and bolts for tightness and spindle damage. Tighten or replace any damaged parts.
2.Stop engine immediately. Replace damaged blade. Only use original equipment blades.
1.Throttle must be set at FULL.
2.Use lower ground speed. Slower the ground speed, better the quality of cut.
3.Raise the deck.
4.Sharpen or replace blades (uncut strip problem only).
1.Inspect rider for cause such as foreign objects stuck in between deck and frame or belt path. Remove obstruction and check for damage. Replace belt if needed.
2.Replace with proper belt. Check Parts list in this manual for correct part number.
3.Engage belt slowly by depressing the blade engagement pedal slowly.
4.Replace with proper belt.
23
