Craftsman 247.770110 manual Removingunitfromcarton, Disconnectingsparkplug, Attachingthe Handle

Rope __

Guide

NOTE: Reference to right and left hand side of the

Yard Vacuum is observed from the operating position. See Figure 1.

This Yard Vacuum has been completely assembled at the factory, except for the handle, bag, and blower chute. These parts are shipped loose in the carton. A pair of safety glasses and a 20-oz. bottle of engine oil are also included in the carton. See Figure 1.

REMOVINGUNITFROMCARTON

•Cut the corners of the carton.

•Remove all loose parts.

•Remove packing material.

•Lift unit from the rear to discard packing material from under unit and roll unit out of carton.

•Check carton thoroughly for any other loose parts.

LOOSEPARTSINCARTON(SeeFigure1)

Blower		•	Handle Assembly
		•	Bag
Chute	Handle
		•	Blower Chute
		•	Safety Glasses (Not Shown)
		• A 20-oz. Bottle of Engine Oil (may be located in
			bag)
		•	Operator's Manual

20-oz. Bottle

of Engine Oil

NutsBag

Lower

Handle

ng

Nuts

Carriage

Screw

Figure 1

IMPORTANT:This unitis shipped without gasoline or oil in the engine. After assembly, see OPERATION section of this manual for proper fuel and engine oil

fill-up.

DISCONNECTINGSPARKPLUG

Before proceeding with assembly of your new Yard Vacuum, disconnect the spark plug wire from the spark plug and ground onto the retaining post on the engine. This will prevent accidental starting of the engine. See Figure 2.

Retaining Post 0

Plug Wire

Figure 2

ATTACHINGTHE HANDLE

•Unfold the upper handle until it aligns with lower handle. Make sure the rope guide is on the right side of upper handle. See Figure 1.