Craftsman 247.79452 owner manual Customer Responsibilities, Important Information

For logs that are not cut square, the longest portion of the log should be rotated down and the most square end placed against the splitting wedge.

Keep your work area clean. Immediately remove splitwood around your splitter so that you do not stumble over it. Clean chips and dirt off end plate (wood platform) after each log is split, or whenever necessary to maintain flat contact between wood and end plate (platform). Never move the log splitterwhile the engine is running.

Never leave your log splitter unattended with the engine running. Shut off the engine if you are leaving your splitter, even for a short period of time. Someone could accidentally activate the splittingwedge and be injured.

Do not run engine in an enclosed area. Exhaust gases contain carbon monoxide. This odorless

gas can be deadly when inhaled.

Be careful not to touch the muffler after the

engine has been running. It will be HOT!

Ifthe equipment should start to vibrate abnormally, stop the engine and check immediately for the cause. Vibration is generally a warning of trouble.

When cleaning, repairing or inspecting, make certain all moving parts have stopped.

Disconnect the spark plug wire and keep the wire away from the plug to prevent accidental starting.

Customer Responsibilities

•Do not operate your splitter in poor mechanical conditionor when in need of repair.

•Periodicallycheck that all nuts, bolts, screws, hose clamps and hydraulic fittings are tight to be sure equipment is in safe working condition. Where appropriate, check all safety guards and shields to be sure they are in the proper position. Never operate your splitter with safety guards, shields or other protective features removed. These safety devices are for your protection.

•Replace all damaged or worn parts such as hydraulic hoses and fittings immediately with manufacturer approved replacement parts.

•Do not change the engine governor settings or overspeed the engine. This increases the hazard of personal injury. The maximum engine speed is preset by the manufacturer and is within safety limits.

•Do not alter your tog splitter in any manner such as attaching a rope or extension to the control lever or adding to the width or height of the

wedge. Such alterations may cause your splitter to be unsafe.

•Perform all recommended maintenance procedures before you use your splitter.

•Do not service or repair your log splitterwithout disconnectingthe spark plug wire and moving it away from the spark plug.

Never store the equipment with gasoline in the tank inside of a building where ignitionsources are present, such as hot water and space heaters, clothes dryers and the like. Allow the engine to cool before storing in any enclosure. Always store gasoline in an approved, tightly sealed container. Store the container in a cool, dry place. Do not store in a building where ignitionsources are present.

•To reduce fire hazard, keep engine free of grass, leaves, wood chips, and excessive grease and oil.

The hydraulic system of your log splitter requires careful inspection, along with the mechanical parts. Be sure to replace frayed, kinked, or otherwise damaged hydraulic components.

•Fluid escaping from a very small hole can be almost invisible. Do not check for leaks with your hand. Escaping fluid under pressure can have sufficient force to penetrate skin, causing serious personal injury. Leaks can be located by passing a piece of cardboard or wood over the suspected leak and looking for discoloration.

•Should it become necessary to loosen or remove any hydraulic fitting or line, be sure to relieve all pressure by shuttingoff the engine and moving the control handle back and forth several times.

Do not remove the cap from the hydraulic tank or reservoir while your log splitteris running. Hot oil under pressure could cause injury.

•The pressure relief valve on your splitter is preset at the factory. Do not adjust the valve. Only a qualified service technician should perform this adjustment.

•Completely drain fuel tank prior to storage. This

guards against accumulation of fuel fumes which could result in a fire hazard.

•Never store log splitter outside without a waterproof cover. Rain will cause rust on the inside of the cylinder.

Important Information

Always:

Use clean fluid and check fluid level regularly

•Use Dexron Ill Automatic Transmission Fluid or lOW non-foaming hydraulic fluid.

•Use a filter (clean or replace regularly)

•Use a breather cap on fluid reservoir

5