Craftsman 247.79452 owner manual uprightpositionReleasespring.lever. See, Final Assembly

uprightpositionReleasespring.lever. See

Figure 4,

Spring

Lever

Jack Stand

Lower the beam assembly to its horizontal position. Make certain the beam is locked securely with the horizontal beam lock. See Figure 5.

Pull the log splitter off the pallet.

Figure 4

Cut the two straps from around the reservoir tank assembly,

Remove the lag screw and washer which secures the beam assembly to the bottom of the

crate.

Final Assembly

Tire Pressure

The tires may have been over-inflated for shipping purposes.

•Check tire pressure regularly. The tire pressure should not exceed 30 p.s.i.

Preparing Log Splitter

Place the logsplitter on a firm, level surface. Lubricate the beam area where the splitting wedge will slide with engine oil (do not use

grease). Make certain to oil both front and back of the beam face.

Fill the reservoir with hydraulic fluid following instructions on page 10.

Check engine oil level and refill, if necessary. Follow instructions for oil fill-up on page 10.

Beam

Assembly

Horizontal--

Beam Lock

Figure 5