SERVICE AND MAINTENANCE
Chute ControlOnce a season or every 25 hours of operation, whichever is earlier, check whether the
To adjust these cables, proceed as follows:
1.Using a ½” wrench, loosen the upper and lower hex nuts found on one cable adjuster.
2.Grasp the metal cable housing and gently push upward to take up slack (usually no more than
3. Repeat on the other cable adjuster until the chute assembly has full range from
Auger Control
Refer to the Assembly section for instructions on adjusting the auger control cable.
Skid Shoes
Figure 21
Refer to the Assembly section for instructions on adjusting the skid shoes.
Belt ReplacementAuger BeltTo remove and replace your snow thrower’s auger belt, proceed as follows:
1.To prevent spillage, remove all fuel from tank by running engine until it stops.
2.Remove the plastic belt cover on the front of the engine by remov- ing the two
3. Roll the auger belt off the engine pulley. See Figure 23.
Figure 22
Figure 23
20