_lb WARNING: Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to doso could result inobjects
being thrown into your eyes, resulting in possible
serious injury.
_WARNING: Do not allow familiarity with your
drillto make you careless. Remember that a
careless fraction of a secondis sufficientto inflict
severe injury.
CHARGING BATrERY PACK
The battery packfor this toolhas been shipped in a
low charge condition to prevent possible problems.
Therefore, you should charge it at least 3 hours prior
to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (drilling
followed by recharging) for them to become fully
charged.
TO CHARGE
•Charge battery pack only with the charger
provided.
•Make sure power supply is normal house
voltage, 120 volts, 60 Hz, AC only.
•Connect charger to battery pack byinserting
charger pluginto inputjack. Asshown infigure 1,
inputjack is located on the back sideof battery
pack.
•Note: Battery pack can remain on your drillor be
removed while charging. When battery pack is out
of the drill, be careful notto touch both terminals
with a metal object. Touching both terminals with a
metal object will short out the batterypack.
•Connect charger to power supply.
•The charge indicator light (LED), located onthe
battery pack, willlight up and glow when the
charger is properlyconnected to power supply. This
lightindicates the charger is operating properly. It
will remain onuntil charger isdisconnected from
power supply. The lightonly glows while your tool is
charging, not dudng use.
•Atternormalusage,3 hoursof chargingtimeis requirsd
tobeful charged.
•The batterypackwill become slightlywarmtothe touch
whilecharging.This is normal and doesnot indicatea
problem.
•DOnot operate the tool while it is connected to the
charger. The driving ability will not increase.
•Do not place charger in an area of extreme heat or
cold. It willwork best at normal roomtemperature.
,_ CAUTION: Your drill's battery pack contains
special high temperature batteries to help prevent
battery damage when left on charge for extended
periods of time. However, once the batteries
become fully charged, we recommend that you
unplug your charger from power supply and
disconnect it from the battery pack.
H