,_ WARNING: Always wear safety goggles or safety glasses with side shields when operating tools.
Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
_ WARNING: Do not allow familiarity with your drill- driver to make you careless. Remember that a careless fraction of a second is sufficient to inflict
severe injury.
BATTERY PACK
The battery pack for your toot has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it overnight prior to use.
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by recharging) for them to become fully charged.
CHARGING BATTERY PACK
See Figure 1.
•Charge battery pack only with the charger provided.
•Make sure power supply is normal household voltage, 120 volts, 60 Hz, AC only.
•Connect charger to power supply.
•Place battery pack in charging stand. Align raised rib on battery pack with groove in charging stand.
See Figure 1.
•Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charging stand.
•The charge indicator light (LED), located on the charging stand, wilt light up red and glow when the charger is properly connected to power supply. This light indicates the charger is operating properly. It will
remain on until battery pack is removed from charging stand or the charger is disconnected from power supply.
•Note: If charger does not charge battery pack, return
battery pack and charger to your nearest Sears Repair Center for electrical check.
•After normal usage, a 3 hours or less of charging time is required to fully recharge battery pack. Note: If battery pack is completely discharged, 6 hours or longer of charging time is required to fully recharge battery pack.
•The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
•Do not place charger in an area of extreme heat or cold. It wilt work best at normal room temperature.
•When batteries become fully charged, unplug charger from power supply and remove the battery pack.
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your
Note: This situation only occurs when continuous use of your drill causes the batteries to become hot. It does not occur under normal circumstances. Refer to "CHARGING BATTERY PACK" for normal recharging of batteries. If the charging assembly does not charge your battery pack under normal circumstances, return both the battery pack
and charger to your nearest Sears repair center for electrical check.
9
