Craftsman 315.115032 operating instructions General, Destroy plastic, Extension Cords, Lubrication

DOUBLE INSULATION is a safety concept in electric power tools, which eliminates the need for the usual three wire grounded power cord and grounded supply system. Wherever there is electric current in the tool there are two complete sets of insulation to protect the user. All exposed metal parts are isolated from internal metal motor components with protecting insulation

IMPORTANT --Servicing of a tool with double insulation requires extreme care and knowledge of the system and should be performed only by a qualified service tecnhician. For service we suggest you re(urn the tool to your nearest Sears Store for repair. Always use original factory replacement parts when servicing,

AWARNING: When servicing use only identical Craftsman replacement parts, Use of any other

parts may create a hazard or cause product damage.

GENERAL

Only the parts shown on parts list, page 13, are intended to be repaired or replaced by the customer. All other parts represent an Jmpprtant part of the double insulation system and should be serviced only by a qualified Sears service technician.

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to vadous types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.

WARNING: Do not at any time let brake fluids,

,_k gaseline, petroleum-based products,penetrating oils, etc, come in contact with plastic parts, They

contain chemicals that can damage, weaken, or

destroy plastic.

When electric tools are used on fiberglass boats, sports cars, wallboard, spackling compounds, or plaster, it has been found that they are subject to accelerated wear and possible premature failure, as the fiberglass chips and grindings are highly abrasive to bearings, brushes, commutators, etc.

Consequently it is not recommended that this tool be used for extended work on any fiberglass material, wallboard, spackling compounds, or plaster, During any use on these materials, it is extremely important that the tool is cleaned frequently by blowing with an air jet.

,_ WARNING; Always wear safety goggles, or safety glasses with side shields during power

tool operation or when blowing dust. If operation is dusty, also weara dust mask.

EXTENSION CORDS

The use of any extension cordwill cause some loss of power. To keep the loss to a minimum and to prevent tool overheating,use an extensioncord that is heavy enoughto cany the current the tool will drew.

Awire gauge size (A.W.G.) of at least 16 is recommendedfor an extension cord 100 feet or less in

length. When workingoutdoors,use an extensioncord that is suitablefor outdooruse. The cord'sjacketwill be marked WA.

ACAUTION: Keep extension cords away from the sandingarea and position the cord so that it will not get caughton lumber, tools, etc., during sandingor polishingoperation,

_k WARNING: Check extension cords before each use. If damaged replace immediately.

Never use tool with a damaged cord since touchingthe damaged area could cause electrical shock resulting in serious injury,

LUBRICATION

All of the bearingsin this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operatingconditions, Therefore,

no further lubdsetionis required.

THE FOLLOWING RECOMMENDED ACCESSORIES ARE CURRENTLY AVAILABLE AT SEARS RETAIL STORES

	Polishing Bonnet		Assorted		Sanding Discs
			150	Gdt	--	Fine
			100	Grit	--	Medium
			60	Gdt	--	Coarse
			40	Grit --Very Coarse
A	WARNING:	The use of attachments or accessories	not listed above			might be hazardous.

11