INSTALLINGBITS
See Figure 6,
•Lock the switch trigger by placing the direction of rotation selector in center position. See Figure 4.
•Open or close chuck jaws to a point where the open- ing is slightly larger than the bit size you intend to use. Also, raise the front of your drill slightly to keep the bit from failing out of the chuck iaws.
Insert drill bit straight into chuck the full length of the jaws as shown in Figure 6.
Tighten the chuck jaws on drill bit.
UNLOCK
DRILLBIT (RELEASE) CHUCKCOLLAR
CHUCKJAWS
LOCK (TIGHTEN)
CHUCKBODY
RIGHT | Fig. 6 |
|
• To tighten the chuck jaws on drill bit; grasp and hold | |||
the | collar | of the | chuck with one hand, while rotating |
the | chuck | body | with your other hand. |
Note: Rotate the chuck body in the direction of the |
REMOVING BITS
See Figure 0.
•Lock the switch trigger by placing the direction of rotation selector in center position. See Figure 4.
•Loosen the chuck jaws from drill bit.
•To loosen: grasp and hold the collar of the chuck with one hand, while rotating chuck body with your other hand. Note: Rotate chuck body in the direction of the arrow marked UNLOCK to loosen chuck jaws.
•Do not use a wrench to tighten or loosen the chuck jaws.
•Remove drill bit from chuck jaws.
ADJUSTABLE TORQUE CLUTCH
Your drill is equipped with an adjustable torque clutch for driving different types of screws into different materials. The proper setting depends on the type of material and the size of screw you are using.
TO ADJUST TORQUE
•Identify the twenty four position torque indicator settings located on the front of your drill. See Figure 8.
•Rotate adjusting ring to the desired setting.
•
•
•
•
•
•
ADJUSTING
arrow marked | LOCK to tighten | chuck jaws. |
• Do not use a | wrench to tighten | or loosen chuck iaws. |
_ WARNING: Make sure to insert drill bit straight into chuck jaws. Do not insert drill bit into chuck jaws
at an angle then tighten, as shown in Figure 7. This could cause drill bit to be thrown from drill, resulting in possible serious personal iniury or damage to the chuck.
TO DECREASE
TORQUE
RING
TO INCREASE |
|
TORQUE | Fig. 8 |
Fig. 7
13