Craftsman 315.175 owner manual Depth of CUT Adjustments, See Figures 4, 5, Belowsubbase

DEPTH OF CUT ADJUSTMENTS

See Figures 4, 5, and 6.

We recommend that cuts be made at a depth not exceeding 1/8 in. and that several passes be made to reach depths of cut greater than 1/8 in.

•Unplug your router.

_k WARNING: Failure to unplug your router could result in accidental starting causing

serious injury.

•Place your router on a flat surface, loosen locking knob, and turn depth adjusting ring until cutter is inside subbase. See Figure 4.

TO
TIGHTEN
LOCKING	CUTTERAT ZERO
	DEPTHOF CUT	Fig. 5

TO	• Position your router so that the cutter can extend
	below the subbase for desired depth setting.
	See Figure 6.

DEPTH

ADJUSTING

RING

DEPTH

INDICATOR

RING

CUTTER	POINT
INSIDESUBBASE	SUBBASE	Fig. 4

•Turn depth adjusting ring until tip of cutter touches flat surface. Turn the depth indicator ring until the zero lines up with the indicator point on the base. Note: The depth indicator ring is also a zero reset indicator when setting cutter at zero depth of cut, then it becomes the depth adjusting ring.

See Figure 5.

CUTrER EXTENDED
BELOWSUBBASE	Fig. 6

•Tum the depth adjusting ring to obtain the desired depth of cut. The distance the cutter moves can be read on the depth adjusting ring. Each mark on the depth adjusting ring indicates 1/16 inch change in depth setting. Indicator point is located on the base.

•Tighten locking knob securely before operating router.

8