Part Names and Functions
Remote Control Battery Installation
1 Open the battery compartment lid.
2 Install new batteries into the compartment.
Two AA size batteries
F o r c o r r e c t p o l a r i t y ( + a n d – ) , b e s u r e battery terminals are in contact with pins in the compartment.
3 | Replace the |
compartment lid. |
To ensure safe operation, please observe the following precautions: ● Use two (2) AA or LR6 type alkaline batteries.
● Always replace batteries in sets.
●Do not use a new battery with a used battery.
●Avoid contact with water or liquid.
●Do not expose the remote control to moisture or heat.
●Do not drop the remote control.
●If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
●Risk of explosion if a battery is replaced by an incorrect type.
●Dispose of used batteries according to the instructions.
Remote Control Operating Range
Point the remote control toward the projector (Infrared | 16.4' | |
(5 m) | ||
Remote Receiver) when pressing the buttons. Maximum | ||
|
operating range for the remote control is about 16.4'(5 m)
and 60 degrees in front of the projector. | 30° |
|
|
| |
| 30° | Remote control |
|
|
Adjustable Feet
Projection angle can be adjusted up to 8.9 degrees with the adjustable feet.
Lift the front of the projector and pull the feet lock latches on both side of the projector upward.
Release the feet lock latches to lock the adjustable feet and rotate the adjustable feet to a proper height, and tilt.
Keystone distortion can be adjusted automatically with the Auto setup function or manually by using the menu operation (see pages 23,
Adjustable Feet | Feet Lock Latches |
13
