OPERATING INSTRUCTIONS

DECORATIVE TRIMMING

 

Decorative trimming is accomplished

 

by removing all vegetation around

 

trees, posts, fences and more. Rotate

 

the whole unit so that the cutting

30º

attachment is at a 30° angle to the

ground (Fig. 7).

Fig. 7

WARNING: Before you begin using any attachment, read and understand the manual that came with the attachment. Follow all safety information contained within.

To Remove Attachments

1.Make sure the unit is turned completely off and unplugged.

2.Turn the knob counterclockwise to loosen the coupler (Fig. 8).

3.Press and hold the release button (Fig. 9).

4.While firmly holding the upper shaft boom (Fig. 10), pull the attachment out of the coupler.

Upper Shaft Boom Attachment

Coupler

Knob

Fig. 10

WARNING: To avoid serious personal injury and damage to the unit, shut the unit off before removing or installing attachments.

CRAFTSMAN CONVERTIBLE™ FEATURE

The coupler allows you to convert this unit for use with add-on attachments as specified in this manual.

To Install Attachments

NOTE: To make installation easier, place the unit on the ground

CAUTION: These attachments are to be snapped into the primary hole only. Using the wrong hole could lead to personal injury or damage to the unit.

CAUTION: Before operating this unit, be sure that the release button is fully snapped into the primary hole (Fig. 9), and that the knob (Fig. 10) is securely tightened.

HOLDING THE UNIT

Before operating the unit, stand in the operating position (Fig.

11). Check for the following:

or on a workbench.

1.Make sure the unit is turned completely off and unplugged.

2.Turn the knob counterclockwise to loosen the coupler (Fig. 8).

3.While firmly holding the attachment, push it straight into the coupler until the release button (Fig. 9) snaps into the primary hole (Fig. 9). The primary hole is on the opposite side of the coupler from the

Attachment

Coupler

Knob

Fig. 8

The operator is wearing eye protection and proper clothing

With a slightly-bent right arm, the operator’s hand is holding the shaft grip

The operator’s left arm is straight, the left hand holding the D-handle

The unit is at waist level

The cutting attachment is parallel to the ground and easily contacts the vegetation without the need to bend over

knob (Fig. 9). Align the release button with the Guide Recess (Fig. 9) to help installation.

4.Turn the knob clockwise to tighten (Fig. 10).

Craftsman Convertible™

Primary Hole Release Button

Coupler

Knob

Guide

 

Recess

 

Fig. 9

CAUTION: Lock the release button in the primary hole (Fig. 9) and securely tighten the knob (Fig. 10) before operating this unit.

Fig. 11

8