Craftsman 320.2819 operating instructions ING the Cutting BIT Figs, Instalung the Cutting BIT

INSTALLING AND REMOV-

ING THE CUTTING BIT (Figs,

3, 4 and 4a)

INSTALUNG THE CUTTING BIT

14Turn router motor off and unplug from power source.

. Remove router motor from

fixed base°

NOTE: See instructions on

removing and installing the router motor in the fixed

base on page 18.

. Set the router motor up- side down on its top cap, with collet/nut pointing up.

4_ Press spindle lock button to engage and lock the spindle shaft and collet/nut (Fig. 3).

5, Place the wrench on the collet/nut and turn coun-

ter-clockwise and loosen col[et!nut slightly to accept cutting bit shank.

6_ Insert cutting bit shank into collet/nut assembly as far as it will go, then back the shank out until the cutters are approximately 1/8 to 1/4 inch away from the face of the collet!nut (Fig. 4, 4a)

With cutting bit inserted and spindle lock button pressed in engaging shaft, place wrench on collet/nut and turn clockwise until router cutting bit and col- let/nut are firmly tightened.

Fig. 3

Collet

Nut

Spindle Lock

Fig° 4

Cutters

Bit Shank

Spindle Lock

Fig,. 4a

Cutters

Collet/Nut

28190 Manual Revised_07_0409 Page 26