Craftsman 320.2819 operating instructions Installing Router Motor in Base

INSTALLING ROUTER MOTOR IN BASE

WARNING: NEVER use the router motor without installing it into either

a fixed or plunge approved base. Failure to do so could result in serious personal injury and damage to router motor.

NOTE: Before installing router motor in fixed base, have the collet/nut and router cutting bit you are going to use already installed in router motor. See

page 16 "INSTALLING AND REMOVING THE CUTTING BIT."

WARNING: ALWAYS turn router motor off and unplug router from power

source before making any adjustments or installing accessories. Failure to

turn router motor off and unplug router could result in accidental starting which can cause serious personal injury.

INSTALLING ROUTER MOTOR IN BASE (Fig_ 5)

1. Turn router motor off and

Fig. 5

unplug from power source.

2.Place fixed base on

flat surface.

F

,With back of fixed base facing you, open router motor clamp (A).

. Press in Coarse Adjust- ment Knob (B) while you align the router motor's slot with the pin in the fixed base.

5.When the router motDr's slot

is aligned and engaged into the base's pin, slide the router motor down base.

A

C

D

into the fixed

6.The router motor wilt now slide up or down to set coarse adjustments when the coarse adjustment knob is pressed in.

7.After all adjustments are made, close the router motor clamp securely.

REMOVING ROUTER MOTOR FROM BASE (Fig. 5)

1.Turn router motor off and unplug from power source. 2_ Place router (fixed base/router motor) on flat surface_

3.With back of router facing you, open the router motor clamp (A).

4.Push in coarse adjustment knob (B) to release router motor "Position groove"

(C)from lock hook (D) in base, while you lift router motor free of base.

5.Set motor upside down on its top cap with collet pointing up and remove cut- ting bit. Store motor and base in carry bag when not being used.

28190 ManuaLRevised_0743409 Page 18