Craftsman 320.2819 operating instructions Safety Rules for Router

SAFETY RULES FOR ROUTER

CAUTION: Cutting bits coast after router is switched off,

O

o

HOLD TOOL by insulated gripping surfaces (handles) when performing

an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make the exposed metal parts of the tool "live" and shock the operator.

Maintain a firm grip on the router with both hands to resist starting torque,

NEVER attempt to use the router motor without first installing it in an approved fixed base. Failure to heed this warning could result in personal

injury and damage to the router motor.

MAKE SURE the router motor does not move up or down when clamped in the fixed base. if router motor is not securely clamped in base, ad- justments will not be accurate.

DO NOT HAND-HOLD THE ROUTER IN AN UPSIDE DOWN OR HORI- ZONTAL POSITION. The router motor can separate from the base if not

properly attached according to the instructions_

TIGHTEN COLLET/NUT securely to prevent the cutting bit from slipping.

if the cotlet/nut is not securely tightened, the cutting bit may detach during use, causing serious personal injury.

NEVER tighten collet/nut without a cutting bit installed in the collet/nut.

O

O

USE CLAMPS or other practical ways to secure and support the work piece to a stable platform and hold the work piece rigidly in position. Holding the work by hand or against your body is unstable and may lead to

loss of control.

NEVER hold the piece being cut in your hands or across your legs. It is

important to support and clamp the work piece properly in order to minimize body exposure, bit binding, or loss of control.

ALWAYS keep chip shield clean and in place.

STAY ALERT and clear the Router cutting bit path of any obstructions BEFORE starting the muter motor. Keep cutting area clear of all foreign objects while muter motor is running.

CHECK TO SEE that the cord will not "hang up" during routing operation.

•MAKE SURE the cutting bit is not in contact with the work piece before the switch is turned on. The bit must ALWAYS be running at full speed before contacting the work piece.

=KEEP HANDS CLEAR OF CUTTING BIT when router motor is running to prevent personal injury.

28190 ManuaLRevised 0743409 Page 8