KNOWYOURTRIMMER
READ THiS OPERATOR'SMANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
Muffler
Assist Handle
Coupler
Shaft
Trimmer
Head
Throttle Trigger
Spark Plug
Shield
/
Primer Bulb
Line Umiter
Blade
Start
Lever
ON/OFF Switch
Starter
Handle
ON/OFF SWITCH
The ON/OFF switch is located on the trigger handle and is used to stop the engine. Move the switch to the OFF position to stop the engine.
PRIMER BULB
The PRIMER BULB removes air from the carburetor and fuel lines and fills
them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate the primer bulb by pressing it and allowing it to return to its original form.
BEFORE STARTING ENGINE
,_WARNING: | Be sure to read |
the fuel information in the safety rules before you begin. If you do not under- stand the safety rules, do not attempt to fuel your unit. Call
FUELING ENGINE
_WARNING: | Remove fuel cap |
slowly when refueling.
START LEVER
The START LEVER helps to supply fuel to the engine to aid in starting. Acti- vate the starting system by moving the start lever to the START position. DO NOT squeeze the throttle trigger until the engine has started and runs. After the engine starts, allow the engine to
COUPLER
The COUPLER enables optional at- tachments to be installed on the unit.
This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality synthetic
brand synthetic oil. Mix gasoline and oil at a ratio of 40:1. A 40:1 ratio is
obtained by mixing 3.2 ounces of oil
with 1 gallon of unleaded gasoline. Included with this trimmer is a 8.2
ounce container of oil. Pour the entire
10
