STEP 2: (SEE FIGURE 2)
•Assemble the latch lock subassembly to the rear tongue using two 1/4" x 1" hex bolts (E) and 1/4" nylock nuts (J). Tighten.
•Assemble the plastic cap (O) to the front end of the rear tongue
LATCH LOCK
(E) 1/4" x 1"FIGURE 2
STEP 4: (SEE FIGURE 4)
•Assemble the hitch bracket to the front tongue using two 3/8" x 1" hex bolts (B) and 3/8" hex nylock nuts
(L). Tighten.•Assemble the leg stand bracket to the front tongue using two 5/16" x 1" hex bolts (C) and 5/16" nylock nuts (K). Tighten.
| LEG STAND | (B) 3/8" x 1" |
| BRACKET | |
| HEX BOLT | |
(C) 5/16" x 1" |
| |
|
| |
HEX BOLT |
| HITCH |
|
| |
|
| BRACKET |
TONGUE
(K) 5/16" NYLOCK NUT (L) 3/8" NYLOCK NUTFIGURE 4
STEP 3: (SEE FIGURE 3)
•Lay the rear tongue (open side facing up) onto the Wheel Support. Assemble the axle through the wheel support and the second hole from the end of the tongue
AXLEREAR
TONGUE
WHEELSUPPORTFIGURE 3
STEP 5: (SEE FIGURE 5)
•Place the front tongue inside the rear tongue as shown in fi gure 5. Fasten the tongues together using a 3/8" x 4" hex bolt (A) and a 3/8" nylock nut (L). Tighten, leaving the nut just loose enough that the tongues can pivot freely.
•Insert the 3/8" x 4" clevis pin (G) through the tongues and secure with a 1/8" hairpin cotter (M).
FRONT | (M) 1/8" HAIRPIN |
TONGUE | COTTER |
HEX BOLT
FIGURE 5
5