STEP 6: (SEE FIGURE 6)
•Assemble an axle clip (S) and a wheel with the valve stem facing out onto the axle. Assemble a hub cap
(P) by pressing or tapping it onto the axle. Repeat on other end of axle.
WHEEL AXLE(S) AXLE CLIP(P) HUB CAPFIGURE 6
FIGURE 7
STEP 7: (SEE FIGURE 7) | STEP 8: (SEE FIGURE 8) |
|
• Insert two 1/4" x | ||
• Attach two noise reduction pads (R) to the bottom of | handle tube as shown in fi gure 8. Holding the bolts in | |
the latch stand bracket. | place in the handle, insert the bolts through the holes | |
| in the poly tray, allowing the legs of the handle to slip | |
• Turn the assembled tongue, wheel support and | beneath the latch stand bracket. Secure the two bolts | |
wheels over to the upright position. Place the latch | with two 1/4" fl at washers (I) and 1/4" nylock nuts (J). | |
stand bracket onto the tongue between the latch lock | Do not tighten yet. |
|
assembly and the raised tab. Place the poly tray onto |
|
|
the wheel support and latch stand bracket. Fasten |
|
|
the tray to the wheel support using eight 5/16" x 3/4" | (J) 1/4" NYLOCK | (I) 1/4" FLAT |
truss head bolts (F) and 5/16" nylock nuts (K). Do not | WASHER | |
tighten yet. | NUT | (D) 1/4" x |
|
| |
• Place the latch stand plate between the latch stand |
| HEX BOLT |
bracket and the poly tray.
LATCH STANDBRACKET
FIGURE 8
6