STEP19: (SEEFIGURE19) Fromtheteftside,inserttheweldedendofthelift handlerodthroughtheholeintheendof thechannel assemblyNext,inserttheliftlinkpinthroughthehole. inthebracketthatisweldedtothelifthandlerod.(The liftlinkis
. Usingthefurnishedgreasepacket,applya light
coatingof greasetothestraightupperportionofthe lifthandlerod.Slidethelifthandletubeontotherod.
STEP 21: (SEE FIGURE 21)
Assemble plastic grip onto lock release grip assembly. Attach tock release grip assembly to lift handle tube using one 5/16" x 1ol/2" hex bolt (C) and one 5/16" nylock nut (K). Do not overtighten the nut. The grip assembly must pivot freely.
. Assemble the bal! end of the cable to a cable end fitting as you did to the other end of the cable. Secure the cable end fitting to the weld bolt on the lock release grip with a 1/4" nylock nut (J). Do not overtighten the lack nut. The cable fitting must pivot freely.
5/16" x 1ol/2" 1/4" WELD
REX BOLT (C) BOLT
|
| CABLE END | ||
|
| FITTmNG | ||
|
|
| CABLE | |
/ |
| 1/4" NYLOCK | ||
PLASTIC | ||||
NUT (J) |
| |||
GRmP |
|
| ||
|
| 5/16"NUT(K)NYLOCK | [ _ | |
S |
| LOCK RELEASE | I | |
f | / | GRUPASSEMBLY | CABLE END | |
|
|
| mTING | |
FIGURE | 21 | (Right | Hand Side View | |
FIGURE19(LeftHandSideView)
STEP20: (SEEFIGURE20)
Removetherubbercapandthefirstjamnutfromthe threadedendofthecontrolcableandslidethemonto
thecontrolcablewire.Adjustthesecondjamnuton thethreadssothatit isapproximately3/4"fromend. Assemblethreadedendofcablethroughthecable mountbracketandsecureitwiththefirstjamnut. Reinstalltherubbercapontothethreadedcableend.
NOTE:Someadjustmentofjamnutsmayberequired
afterbladeassemblyiscompleted.
CABLE MOUNT BRACKET
\
JAM NUTS
_- RUBBER
CAP
FIGURE 20 | (Right Hand Side View) |
STEP 22: (SEE FIGURE 22)
Place the end of the blade pivot rod down through the blade pivot shaft. Attach the other end of the blade pivot rod to the lift handle tube. Secure both ends with a hairpin cotter (O). The holes for the hairpin cotters should be parallel to the ground.
Use the two plastic ties to hold the cable securely to the outside of the handle tube and away from the tractor to avoid direct heat from the tractor muffler.
. Squeeze the grip assembly to check blade pivot. To adjust, see Service & Adjustments section on p. 13.
PLASTIC TreES
BLADE | PWOT |
ROD | LiFT HANDLE |
| TUBE |
BLADE
PIVOT SHAFT
HAIRPmN COTTER(O)
FIGURE 22 | (Left Hand Side View |
10
