STEP8: (SEEFIGURE8)
,AttachtheR.H.hangerbrackettothethreeholesshown onthesideofthetractorframeusingthree3/8"x 1"hex bolts(D).3/8"tockwashers(R)and3/8"fiatwashers.
Use3/8"nylocknuts(L)oninsideofframeifboltsinsert
freelyintoholesTighten. .
,Repeatforotherside.
NOTE:Usespecial3/8"x 1"threadformingbolts(G)inany holesthataretoosmallforregularbolts.
318" x 1" HEX BOLT (D)
(OR THREAD FORMUNG
BOLT (G} IF NEEDED)
318"LOCK
WASHER (R) 3/8" NYLOCK NUT (L) (UFNEEDED)
\\
FIGURE 8
iNSTRUCTiONS FOR ALLTRACTORS
STEP 9: (SEE FIGURE 9)
,Assemble one angle support bracket to the topmost set of holes in the hanger brackets using two 3/8" x 1" hex bolts (D) and 3/8" nylock nuts (L). Assemble the second angle support bracket to the second from the bottom set of holes in the hanger brackets using two 3/8" x 1" hex bolts (D) and 3/8" nylock nuts (L). Be sure the brackets are turned as shown. Do not tighten yet.
X3/8" x 1
HEX BOLT (D)_
318" NYLOCK | / | |
| ||
NUT | (L) |
|
/ |
| ANGLE SUPPORT |
|
| BRACKET |
FIGURE 9
STEP 10: (SEE FIGURE 10)
,Assemble the pivot support bracket to the angle support brackets using four 3/8" x 1" hex bolts (D) and four 3/8" nylock nuts (L). Do not tighten yet.
Tighten the 4 bolts fastening the angle support brackets to the hanger brackets.
Tighten the 4 bolts fastening the pivot support bracket to the angle support brackets.
3/8" NYLOCK
NUT (L)
PIVOT SUPPORT
BRACKET
FIGURE 10
STEP 11: (SEE FIGURE 11)
,Assemble the two angle lock bars together as shown in figure 6. so that a!l holes are aligned. Use one 3/8" x 1ol/4" carriage bolt (E) and one 3/8" nylock nut (L). Be sure to insert bolt from side indicated. Do not tighten at this time.
,Hold the angle lock bars so that the square holes are at the top= Insert the straight hook end of the angle lock spring through the small middle hole in both angle lock bars=
3/8" NYLOCK NUT (L)
%
3/8" x
CARRIAGE BOLT (E} \
ANGLELOCK ANGLE LOCK SPRmNG
BARS
FIGURE 11 | (Right Hand Side View) |
7
