iNSTRUCTiONS FOR TRACTORS WITH DUAL
FRONT DECK SUSPENSmON BRACKETS
STEP 4: (SEE FIGURE 4)
Compare your tractor to the illustrations shown Jn figure 4. If your tractor resembles the top illustration, go to step 5. If your tractor resembles the bottom illustration, go to step 7.
TYPE A
\
FRONT SUSPENSION
BRACKET
BRACKET
FIGURE 4
iNSTRUCTiONS FOR TYPE A TRACTORS
STEP 5: (SEE FIGURE 5)
Remove any bolts found in the holes indicated in the illustration.
REMOVE BOLTS FROM THESE HOLES
FRONT
SUSPENSUON
BRACKET
FIGURE 5
STEP 6: (SEE FIGURE 6)
Attach the R.H. hanger bracket to the two front empty holes on the right side of the tractor frame using two new 3/8" x 1" hex bolts (D), 3/8" lock washers (L), and 3/8" flat washers (N) as shown. For the rear hole, use a 3/8" x 1" hex bolt (D), 3/8" lock washer (L) and 3/8" flat washer (N) with a large 1/2" washer (M) placed between the hanger bracket and the tractor frame. Tighten. Repeat for the left side.
,Skip to step 9.
3/8" FLAT WASHER(N)
1/2" LARGE
318"LOCK | WASHER (M) | ||
WASHER (L) | |||
| |||
3/8" x 1" | X |
| |
REX BOLT | (D) \ |
| |
\
R.H. HANGER
BRACKET
FtGURE 6
iNSTRUCTiONS FOR TYPE B TRACTORS
STEP 7: (SEE FIGURE 7)
Remove any botts found in the holes indicated in the illustration.
REMOVE BOLTS FROM
THESE HOLES
FRONT
SUSPENSION
BRACKET
FIGURE 7
