Craftsman 486.24717 manual Washer, Loosen 4 bolts 1/4 turn each

•Assemblea shorttarpstrapto reardoorusingone 1/4"x 1-1/4"hexbolt,two1/4"flatwashersandone 1/4"nylocknut.Assemblean"S"hookthroughloose endofstrap.Seefigure15.Repeatonothersideof door. Assembledoortorearofcartbyrestingbottomof

doorondoorsupportsandpushingtopofdoorin againstcrossbraceSecuretopofdoorusingdoor. latchesoneachside.Seefigure15. Hookboththetarpstrapsontothe1/4"x 1"hexbolts inthesidesofthecart.Seefigure15.

DOOR LATCH

1/4" x 1-1/4" HEX BOLT 1/4" FLAT WASHER

STRAP (SHORT)

1/4" FLAT

WASHER

	DOOR
1/4" NYLOCK NUT	SUPPORTS

1/4" x 1"

HEX BOLT

FIGURE 15

Attach the engine/impeller housing assembly to the upper holes in the angles welded to the tongue. Use four 5/16" x 3/4" hex bolts and 5/16" nylock nuts. Tighten. See figure 16.

5/16"

NYLOCK NUT

	i
	I
_	5/16" x 3/4"
_	HEX BOLT
	/

WELDEDFRON

ANGLES_TONGUE

FIGURE 16

Assemble the elbow to the impeller housing using four 5/16" x 3/4" thread forming hex bolts and four nylon washers. Push while turning to help start the bolts into the unthreaded holes. Tighten. See figure 17.

To center the elbow with the opening in the hard top: a. Push the vinyl boot back inside the opening.

b. Loosen by approximately 1/4 turn each, the four bolts that you assembled in figure 17.

c. Push against the elbow to center it with the sides of the opening.

d. Retighten the four bolts that you loosened. Pull the vinyl boot onto the end of the elbow.

Center elbow between

sides of opening

NYLON

WASHER

5/16" x 3/4"

HEX BOLT

(Thread Forming) __

Loosen (4) bolts 1/4 turn each

FIGURE 17

1 2	Call 1-866-576-8388 for missing parts or assembly help
	DO NOT RETURN TO STORE