ASSEMBLY
i i | iiiii lUU i iiiillU, UUl | i i ii ii iiill |
TO iNSTALL CHUTE ASSEMBLY TO
CHUTE FLANGE
CHUTE
ASSEMBLY
Q Remove the chute assembly from the carton
•_Usinga 1/2 inch wrench or adjustable wrench, re- move the three (3) nuts, Iockwashers, flatwashers and carriage bolts from the chute flange°
®PPlacethe chute assembly over the outside of the _chute flange so that the "A" on the chute assembly is next to the "A" on the chute flange This will al+gn 'al!three holes correctly+
•_.Fromthe inside of the chute flange, insert the three
[(3) carriage bolts (removed earlier) through the
\
ithree square holes The square part of the carnage bolls should fit into the square holes in the chute
+!lange+
®.lnstall the three (3) flatwashers, !ockwashers and
'nuts(removed earlier) on the carriage bolts. t
: ._,Juu.ltl
CAUTION: IF ALL THE THREE (3) CARRIAGE
'_ BOLTS CANNOT BE MOUNTED, THE HOLES ARE NOT ALIGNED CORRECTLY.CHECK THE
POSITION OF THE LETTER "A's"ON THE CH_JTEASSEMBLY AND CHU_ FLANGE. THEY MUST
BE NEXT TO EACH OTHER+IF LESS THAN THREE (3) HOLES LINE UP,YOU HAVE MOUNTED THE CHUTE AS-
SEMBLY INCORRECTt.Y AND SNOW COULD BE DIS-
CHARGED TOWARD THE OPERATOR.RE+INSTALLTHE CHUTE ASSEMBLY IF NECESSARY.
NUT
LOCKWASHER
FLATWASHER CARRIAGE
BOLT
(SHOWN
CHUTt
SQUARE
HOLE IN
CHUTE FLANGE
A
FIG. 8
t
<
10
