J ,,,,, i | _ ,,,,,,,, | 1,1,,, | • | ,,I,H, | .... ,,, | =1,=,,=, | ,,,,, | , | , | ,, ,, |
|
|
|
| ASSEMBLY |
|
|
|
| ||
.....................................ii | ,,1,, | ,,, | ,,, |
TO INSTALL THE SHIFTER LEVER
KNOB
•Stand the snow thrower up on the front of the auger housing, as shown in Fig 6A,
•Cut the plastic tie which holds the shifter lever assembly to the shift bracket (Fig 6B).
•Remove the Iocknut, washer, spring and bolt (Fig. 6D) ....
•Reposition the shifter lever into the slot in the control panel, as shown in Fig 6C and reinstall the bolt, spring, washer and tocknut.
•Tighten the Iocknut until t/8" to 3/16" (2 or 3 threads) of the bolt protrude past the locknut.
•Thread the shifter lever knob onto the threaded endof the shifter lever until it is tight (Fig 6D)
OMovethe shifter lever through allthe speedsto ensure proper tension of the spring,, If the shifter lever sticks in any of the notches, loosen the Iocknut 1/4 turn at a time until the shifter lever moves freely.
, | ,H,,,,,,, | =,,,i | N,,,,, | =1=,,, | ,, | i,,,,, |
| H,,, | H, |
| ,,,,,,,,,!, |
| i i ,,,,,,,,,,, |
SHIFTER
BRACKET
TO INSTALL HEADLIGHT
The headlight is mounted on right side of upper handle and is installed upside down for shipping purposes
@Remove the pivot bolt (Fig., 7A), ptace headlight in correct position (as shown in Fig. 7B and in Fig 2) and retighten nut.
•Tie the headlight cable to upper and lower handles with the plastic cable ties supplied in the parts bag by threading the pointed ends ot each tie through the square ends and pulling tightly around the headlight cable and the handle.,
NOTE: One side of the plastic tie has small notches in it, while the other side is smooth The notched side must be
on the inside of the loop which is formed when the ends are put together
@Tryto _oosen the cable tie If it can be loosened, it has been attached with the smooth side on the inside of the loop, Remove the cabletie and reverse itsdirection
O Cut off excess cable tie,
LOCKNUT
WASHI
1/8 TO 3/16 INCH OF EXPOSED THREADS
FIG, 6
FIG. 7A | FIG. 7B |
