PRODUCT SPECIFICATIONS
HORSEPOWER | 11.0 HP |
|
DISPLACEMENT | 21.82 cu. in. | |
GASOLINE | 4 quarts |
|
CAPACITY | (unleaded) |
|
OIL CAPACITY | 5W30 |
|
(20 oz capacity) |
|
|
SPARK PLUG: | Champion | RJ19LM |
| (Gap .030 | in.) or |
| equivalent |
|
VALVE CLEARANCE: | Intake: .010 In. | |
| Exhaust: | .010 in. |
SNOW THROWER
AS REQUIRED
The following adjustment should be preformed more than once each sea- son.
1.Auger drive belt should be adjusted after the first 2 to 4 hours of use, again about
LUBRICATION-EVERY 25 HOURS
Lubricate Disc Drive Plate every
To Lubricate
1.Position speed selector lever in first gear.
2.Stand the snow thrower up on the auger housing end.
3.Remove the bottom panel.
4.Turn disc drive plate clockwise by hand until grease zerk is cleady visible at front center, See
Figure 16.
5.Place a coin or (a shim of equal thickness) between the rubber fric- tion wheel and disc drive plate to
prevent rubber friction wheel con- tacting the drive disc plate.
6.To grease zerk, use a hand grease gun, lubricate with a Hi Temp EP
Moly grease. Fill zerk only until grease becomes visible below bear-
ing assembly located under grease zerk. DO NOT over fill.
CAUTION: DO NOT allow grease to come in contract with the disc drive
plate or friction wheel or damage will result.
IMPORTANT: Remove coin and en- sure that a gap exists between friction
wheel and disc drive plate.
NOTE: Clean all excess grease found on friction disc hub.
Sprockets Hex Shaft and Sprockets
(Require No
Lubrication
Friction
Disc
Drive
Plate
\
Friction Bearing
E_WheelAssembly Point at which
Coin or Shim grease should
be visible
Gap Between
Friction Wheel
and Disc Drive Plate
Grease Zerk
Figure 16
LUBRICATION-NOT REQUIRED
1.Hex Shaft and Sprockets- Hex shaft and sprockets require no lu- brication. All bearings and bushings are lifetime lubricated and require no maintenance. See Figure 16.
NOTE: Any greasing or oiling of the above components can cause contami- nation of the friction wheel. If the disc
