ASSEMBLY
Read these instructions and Operator's Manual in its en- tirety before you attempt to assemble or operate your new high pressure washer. Your high pressure washer has, for the most part, been assembled at the factory, except those parts left unassembled_ Before you can operate your new high pressure washer, you must assemble the wheel kit and properly connect the high pressure hose.
IF YOU HAVE ANY PROBLEMS WITH THE ASSEMBLY OF YOUR PRESSURE WASHER, PLEASE CALL THE PRESSURE WASHER HELPLINE AT
TOOLS REQUIRED FOR ASSEMBLY
,,Mallet
o2 adjustable wrenches OR the following wrenches: o 5/16" (8mm) combination wrench
*1/2" (13mm) combination wrench
,,11/16" (18ram) combination wrench ° 7/8" (22mm) combination wrench
o15/16" (24mm) combination wrench
TO REMOVE PRESSURE WASHER FROM
CARTON
oRemove box for spray gun assembly and support legs = Remove accessories box from carton.
°Remove wire basket (wrapped in plastic) o Removeyour high pressure washer.
Refer to Page 6, "Contents of Hardware Pack" for an illustrated listing of all items included with your pressure washer. Become familiar with each piece before assem- bling pressure washer. Check all contents against illustra- tions on Page 6. If any parts are missing or damaged, call Pressure Washer Helpline. at
HOW TO SET UP YOUR PRESSURE WASHER
TO INSTALL THE WHEEL KIT
Installing the wheel kit requires the tools listed above, the guide handle and items included in the parts carton.
,,Prop up the engine end of the main uniL This will allow you to slip each axle pin into the holes provided on the side of the base (Fig. 1)
oFasten each axle to base with
=Place wheels with valve side of wheel facing outboard side onto the axles and retain each wheel to its axle by tapping a push nut onto end of axle with a malleL
o Insert foot pad into bottom of each support leg (Fig. 2).
=Using 13mm or
oAttach guide handle to cradle (Fig. 3) with two
HEEL
FIG. 1
QAPSCR_
CRADLE FRAME
WASHER
/
<
FOOT PAD
GUIDE HANDLE
CRADLE FRAME
REAR WAND HOLDER - Rest spraygun here
FIG. 3
7
