Craftsman 580.75201 Engine Maintenance, Pump Maintenance, Checking OH Leve, Service Air Cleaner

Pump Maintenance

Changing Pump Oit

Change oU every 50 hours or once yearly, whichever occurs first.

NOTE: You must purchase an approved bottle of pump off by calling 1-800-366-PART or online at www.sears, com.

Change pump oil as follows:

1.Drain engine oil and fuel from pressure washer.

2.Use a 8mm allen wrench to remove black pump

oil cap between high pressure outlet and garden hose inlet.

Oil Cap

3.TiJt pressure washer to drain oil into an approved container until it drips slowly from pump.

4.Tilt pressure washer in opposite direction and empty premeasured pump oiJ bottle into same opening (a small funnel may be helpful).

5.)nstaU black pump oJ(cap and tighten firmly.

6.Set pressure washer in upright position. Add fuel and engine oil.

ENGINE MAINTENANCE

Checking OH Leve(

Oil level should be checked prior to each use or at least every 8 hours of operation. Keep oil level maintained.

Change oit while engine is still warm from running, as follows:

1.Drain fuel tank by running pressure washer until fuel tank is empty.

2.Disconnect spark plug wire and keep it away from spark plug.

3.Clean area around oil fill, remove oil fill cap/dipstick. Wipe dipstick clean.

4.Tip your pressure washer to drain oil from oil fill into a suitable container making sure you tip your unit away from spark plug and air cleaner. When crankcase is empty, return pressure washer to upright position.

5.Wipe dipstick clean, insert it into oil fill hole and tighten securely, remove dipstick. Add recommended oil up to "Full" mark on dipstick.

Pour slowly. Wipe dipstick clean each time oil level is checked. DO NOT overfill.

6.Install oil fill cap/dipstick, tighten securely.

7.Wipe up any remaining oil.

8.Reconnect spark plug wire to spark plug.

Service Air Cleaner

Your engine will not run properly and may be damaged if you run it with a dirty air cleaner.

Service the air cleaner once every 25 hours of operation or once each year, whichever comes first. Service more often if operating under dirty or dusty conditions. Replacements are available at your local Sears service center.

To service the air c(eaner, fo)iow these steps:

1.Remove screw.

Changing Oil

Change engine oil after the first 5 hours and every 50 hours thereafter. If you are using your pressure washer under extremely dirty or dusty conditions, or in extremely hot weather, change oil more often.

( cAuTmO.

•Used motor oil has been shown to cause skin cancer in certain laboratory animals,

•Thoroughly wash exposed areas with soap and water,

KEEP OUT OF REACH OF CHILDREN. DON'T POLLUTE. CONSERVE

RESOURCES. RETURN USED OIL TO _COLLECT)ON CENTERS.

2.Carefully remove air cleaner assembly to prevent debris from falling into carburetor.

3.Take air cleaner assembly apart and clean all parts. Wash foam air cleaner in liquid detergent and water. Squeeze dry in a clean cloth.

4.SATURATE foam air cleaner in engine oil and squeeze in a clean cloth to remove excess oil.

5.Reinstall clean or new foam air cleaner in body.

6.Install air cleaner securely on carburetor with screw.

NOTE: You can purchase new air cleaner elements by ca(ling 1-800-366-PART.

15