5.Usinga gardenhose,removeadditionaldebrisby backflushingwaterthroughnozzleextensionBack. flushbetween30to60secondsTurnadjustable. nozzleextensiontostreamsprayandmovenozzle fromlowto highwhileflushing.
6.
7.Reconnectnozzleextensionto spraygun.
8.Reconnectwatersupply,turnonwater,andstart
engine.
9.Testpressurewasherbyoperatingwithnozzlein highandlowpositions.
O-Ring Maintenance
Purchase an
included with the pressure washer. This kit includes replacement
Pump Maintenance
6.Set pressure washer in upright position. Add fuel and engine oil.
ENGINE MAINTENANCE
WARNING
WHEN ADJUSTING OR MAKING REPAIRS TO YOUR
PRESSURE WASHER
*Disconnect the spark plug wire from the spark plug and place the wire where it cannot contact spark plug.
WHEN TESTING FOR ENGINE SPARK
Use approved spark plug tester.
DO NOT check for spark with spark plug removed.
Checking Oil Level
Oil level should be checked prior to each use or at least every 8 hours of operation. Keep oil level maintained.
Changing Oil
Change engine oil after the first 5 hours and every 50 hours thereafter. If you are using your pressure washer under extremely dirty or dusty conditions, or in extremely hot weather, change oil more often.
CAUTION
Changing Pump Oit
Change oil every 50 hours or once yearly, whichever occurs first.
NOTE: You must purchase a premeasured bottle of pump oil, item number 190586GS, by calling
Change pump oit as follows:
1.Drain engine oil and fuel from pressure washer.
2.Use a 8mm allen wrench to remove black pump oil cap between high pressure outlet and garden hose inlet.
O ..............
"_ | Oil Cap |
kk.....
3.Tilt pressure washer to drain oil into an approved container until it drips slowly from pump.
4.Tilt pressure washer in opposite direction and empty premeasured pump oil bottle into same opening (a small funnel may be helpful).
5.Install black pump oil cap and tighten firmly.
Used motor oil has been shown to cause skin cancer in certain laboratory animals.
Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN.
DON'T POLLUTE. CONSERVE
RESOURCES. RETURN USED OiL TO
COLLECTION CENTERS.
Change oil while engine is still warm from running, as foJtows:
1.Drain fuel tank by running pressure washer until fuel tank is empty.
2.Disconnect spark plug wire and keep it away from spark plug.
3.Clean area around oil fill, remove oil fill cap/dipstick. Wipe dipstick clean.
4.Tip your pressure washer to drain oil from oil fill into a suitable container making sure you tip your unit away from spark plug and air cleaner. When crankcase is empty, return pressure washer to upright position.
5.Wipe dipstick clean, insert it into oil fill hole and tighten securely, remove dipstick. Add recommended oil up to "Fuji" mark on dipstick.
Pour slowly. Wipe dipstick clean each time oil level is checked. DO NOT overfill
15
