Connect Hose and Water Supply to Pump
IMPORTANT: To avoid pump damage, you must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine.
1.Uncoil high pressure hose and attach one end of hose to base of spray gun. Tighten by hand.
. Remove and discard shipping caps from pump inlet and outlet.
3.Attach other end of high pressure hose to high pressure outlet on pump. Tighten by hand.
CAUTION
*Damage to equipment resulting from failure to follow this instruction will void warranty.
7.Turn ON water and squeeze trigger on spray gun to purge pump system of air and impurities.
WARNING
Always wear eye protection when using this equipment or in vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing adequate eye protection.
. Before connecting garden hose to water inlet, inspect inlet screen. Clean screen if it contains debris or have it replaced if damaged. Refer to section
inspect inlet
NOT use if damaged; clean if dirty.
. Run water through garden hose for 30 seconds to flush it of debris. Turn off water.
IMPORTANT: DO NOT siphon standing water for the water supply. Use ONLY cold water (less than 100°F).
6.Connect garden hose (not to exceed 50 feet in length) to water inlet. Tighten by hand.
CHECKUST BEFORE STARTING
Review the unit to ensure you have performed all of the following:
1.Check that oil has been added to proper level in engine crankcase.
2.Add proper gasoline to fuel tank.
3.Check for properly tightened hose connections (high pressure and water supply) and that there are no kinks, cuts, or damage to high pressure hose.
4.Provide proper water supply (not to exceed 100°F).
5.Be sure to read "Safety Rules" and "Operation" sections before using the pressure washer.
6.If starting unit after storage, see "Storage" section on pages
