Craftsman 580.768020 manual Rings, yellow, p/n B2264 for the ends

•Use the wire included in the kit or a small paper

clip to free the foreign rcatedals clogging or restricting the nozzle.

Insert wire into nozzle and turn back and forth to clear obstruction.

Parts in the O-Ring Kit Include:

1 o-dng, red, (pin B2726) for the end of the spray

gun connection between gun and high/low spray wand.

Remove additional debris by back flushing water
supply through wand. Back flush between _ to 60
seconds. Turn wand to stream spray and mbve	• 2 o-rings, yellow, (p/n B2264) for the ends of the
nozzle from low to high pressure while flushing.
	high pressure hose.

•"Reinstall nozzle into wand. DO NOT overtighten.

•Reconnect wand extension to spray gun.

•Reconnect the water supply, turn O1_the1 water, and start the engine.

•Test the cleaning system by operating with nozzle in the high and the low pressure positions.

O-RingMaintenance

Through the normal operation of your cleaning system, the o-rings keep the connections of the hoses and gun tight and leak-free. They may become worn or damaged with use. Provided with your cleaning

system is an O---ring Maintenance Kit containing replacement o-dngs, a rubber washer and a garden hose inlet screen.

Note: The above two o-dngs are close in size. Please match carefully to assure proper o--dng usage.

•1 rubber washer (pin B2385) for the inside of the garden hose connector.

•1 water inlet screen (p/n B2384) for the garden hose connector.

To remove a worn or damagedO-Ring:

•Use a small flathead screwdriver to get underneath the o-ring and pry it off.

11