Toaddfueltoengine:
•Clean area around fuel cap, remove cap.
•Add regular unleaded gasoline, slowly, to the fuel tank.
Important: Never mix oil with gasoline.
•Install fuel cap and wipe up any spilled gasoline.
TO START THE CLEANING SYSTEM
The best way to start your cleaning system engine for the first time is to follow these
you start the engine after you have let the cleaning system sit idle for at least a day.
•Place the cleaning system in an area close enough
to an outside water source that can flow at ;_ rate of at least 3 gallons per minute. Connect a garden hose to the water spout.
•Check that the high pressure hose is tightly
connected to the spray gun and to the pump. See ASSEMBLY section on page/4.
•Check inlet screen on the water inlet. If the screen is dirty, clean before attaching a garden hose. If the screen is damaged, do not connect to the garden hose. Replace with screen provided in maintenance
kit or call
•Attach the the garden hose to the water inlet.
•Tum on the water.
Important: Do not run pump without the water supply connected and turned on. You must follow this
caution or the pump will be damaged.
•Remove the adjustable nozzle extension from the spray gun.
•Pull the trigger on the spray gun and hold until a steady stream of water appears.
•Engage the safety latch on the spray gun.
Safety Latch
•Attach adjustable nozzle extension onto spray gun.
•Pull choke lever all the way out to the =FULL
CHOKE POSITION."
Choke Lever
in =Full Choke
Position"
Note: If restarting a warm engine after a short shutdown, move choke lever to =NO CHOKE PosmoN."
•Move Run/Stop switch to the "1" or on position.
8
