•Grasp starter handle and pull slowly until you feel some resistance. Then pull cord rapidly to overcome compression, prevent kickback and start the engine. Let rope return to starter slowly.
Note: The Pressure Command TM may be placed in any position during starting or operation.
•When engine starts, move choke lever to "1/2
CHOKE" until engine runs smoothly and then to "NO CHOKE POSITION." If engine falters, move choke lever to =1/2 CHOKE" until engine runs smoothly and then to "NO CHOKE POSITION."
Note: If the engine fails to start after 3 pulls, move
choke lever to "NO CHOKE POSITION" and pul! starter rope again.
Note: If engine fires, but does not continue to run, move choke lever to "FULL CHOKE" and repeat, starting instructions.
•Once the engine has started, disengage the slSray gun safety latch.
HOW TO STOP YOUR PRESSURE WASHER
Important: Do not run pump without the water supply connected and turned on. You must follow this caution
or the pump will be damaged.
•Move the Run/Stop switch to the "0" or OFF position.
•Simply shutting off the engine will not release pressure in the system. Squeeze trigger on the spray gun to relieve pressure in the hose.
Note: A small amount of water will squirt out when you release the pressure.
•Rotate the
OFF position to prevent chemical leakage.
SIPHONING
We recommend that you DO NOT siphon standing water for your water supply. Contaminated, brackish or
dirty water can damage the pump. Connect only to household water supply.
TIPS
•Never use the garden hose inlet to siphon detergent or wax.
•If you hold the spray nozzle too far away from the
object being cleaned, washing will not be as effective.
•Always store the cleaning system with the
9
