TO START ENGINE
1, Attach spark ptug wire and boot to spark plug
2.Place the throttle control lever in START position See figure 8
3.Grasp starter handfe (see figure 9) and pull rope out slowly until engine reaches start of compres-
sion cycle (rope will pull slightly harder at this point). Let the rope rewind slowly
NOTE: A noise will be heard when finding the
start of the compression cycle This notice is caused by the flails and fingers which are part
of the shredding mechanism falling into ptace, and should be expected,
4Pull rope with a rapid, continuous, full arm stroke Keep a firm grip on start handle Let rope rewind
slowly. Do not let starter handle snap back against starter,
5, | Repeat preceding instructions | 3 | and 4 until engine | ||
| fires, |
|
|
|
|
6, | After engine starts, move throttle | control | lever on | ||
| engine to slow position for a few minutes warm up, | ||||
| Then move throttle control lever to RUN position | ||||
| for | operations |
|
| |
|
|
| _ | Air | |
|
| - |
| i | .Screen |
FIGURE 9.
TO STOP ENGINE
1Move throttle control lever to STOP position See figure 8
2, Disconnect spark plug wire from spark p_ug and ground against the engine to prevent accidental starting while equipment is unattended
i wARN,I G
The
with considerable velocity Keep away from the area around the discharge chute Always stop the engine and d_sconnect the spark plug wire when removing or
attaching the bag when changing
containers or when removing the shredded material
if if becomes necessary to push materials into the
Do not deposit material larger then 12" diameter in the hoppe_ or upper guide extension Any material heavier then 1/2" should be fed _nto the
Leaves and smaller branches can be fed into the
hopper with the leaf ramp raised as shown in figures 10 and 11
Hopper
Guide
HOW TO USE YOUR CHIPPER-SHREDDER
Your shredder is designed for safe, efficient operation.
KEEP HANDS AND FEETAWAY FROM ALL OPENINGS
WARNING
Wear the safety glasses provided with your unit while operating the chipper- shredder to prevent injury from any chips
which may be ejected out of the
openings, Make certain
Wear gloves when handling material Feed material
into the
to determine what rate provides the best results
without stalling the engine or plugging the discharge chute.
The discharge chute will direct the shredded material into a pile, a container or the bag provided with your shredder
FIGURE 10.
Leaf
Ramp
FIGURE 11
No larger than 112 inch diameter
)or