another free manual from www.searstractormanuals.com
18.SJide Idler Shaft Assembly into Tractor Channel (Fig. 4).
17. 1nstall Spring:
LOOP
one spring found in bag of parts.
Hook Offset Loop of Spring into hole in rear of Front Axle Bracket. Hook other loop of Spring in hole in Idler Shaft Assembly (Fig. 5).
18.Remove the two Retainer Springs and Engine Belt Guard, (Fig. 4 - too inset).
19.Remove Nut, Lockwasher and Belt Guide. Place Belt on Idler Sheaves and on Engine Pulley. NOTE: See Fig. 6 for proper way of installing Belts on Idler Sheaves. Backside (outside) of Belt must be placed in Flat (outside) Idler.
Belt must be placed in largest groove on Engine Pulley.
2 O.Assemble Adjusting Pin:
0~
one of two Pins found in bag of parts.
Assemble Adjusting Pin to threaded end of Belt Tightener Link (Fig . 5 · left hand inset).
2 1.Secure Link to Belt Tightener Lever Arm with Retainer Spring:
the smallest of three Retainer Springs found in bag of parts. Install Belt Tightener Link through opening in Idler Shaft Assembly. Attach bent end of Link to rear end of Belt Tightener Lever Arm. Secure Retainer Spring (Fig. 4 · left hand inset).
BE LT
GUIDE
FIGURE 4
FIGURE 5
FIGURE 6
·3·