Craftsman 917.270631 owner manual To Replace Fuse, To Remove Hood And Grill Assembly

TO REPLACE HEADLIGHT BULB o Raise hood.

o Pul! bulb holder out of the hole in the backside of the grill

o Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill°

o Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or pre- vent it from starting.

o Check wiring. See electrical wiring dia- gram in the Repair Parts section of this manual

TO REPLACE FUSE

Replace with 30 amp automotiveotype

plug-in fuse° The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL

ASSEMBLY

•Raise hood.

o Unsnap headlight wire connector.

o Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

o To replace, reverse above procedures_

Hood

Headlight

Wire

Connector

ENGUNE

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers expense, may be performed by any non- road engine repair establishment or indi- vidual. Warranty repairs must be per- formed by an authorized engine manufac- turer's service outteL

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be nec_ essary. Check adjustment as described below before loosening cable, if adjust- ment is necessary, proceed as follows:

o With engine not running, move throttle control lever from stow to choke posi- tiono Slowly move lever from choke to fast position.

°Check that holes "A" in governor control lever and hole in governor plate line-up. If holes "A" are not aligned, loosen clamp screw and move throttle cable

until holes are aligned. Tighten clamp screw securely.

Governor	Governor
Control Lever	Control Plate

\

Clamp

	Screw	Throttle
		Cable
Holes "A"

25