ASSEMBLY
FRONT HANDLE
See Figure 2.
1.Remove the front handle, bolt and wing nut from the Owner’s Kit.
2.Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position.
3.Place the bolt through the front handle as shown. Then install the wing nut.
4.Tighten wing nut securely.
NOTE: Do not attempt to remove or modify the spacer. This spacer limits the upper position of the handle grip. See Figure 2.
SILENCER GUARD ASSEMBLY
See Figure 3.
1.Remove silencer guard and two screws from the owner’s kit.
2.Attach the silencer guard to the rear housing.
NOTE: Make sure the bent end of the silencer guard fits securely into the opening of the rear housing.
3.Install two screws.
4.Tighten screws securely.
7
FRONT HANDLE
BOLT
SCREWS
WING NUT
Fig. 2
REAR HOUSING
SILENCER 
GUARD
BENT END OF
SILENCER GUARD
OPENING IN REAR
HOUSING
Fig. 3
