ASSEMBLY
ASSEMBLY INSTRUCTIONS:
EDGER GUIDE ASSEMBLY
See Figure 4.
1.Assemble the two plastic pieces of the edger guide together using the short bolt, flat washer, lock washer and wing nut.
2.Slide the edger guide to adjust it to the desired trimming length.
3.Tighten the wing nut securely.
GRASS DEFLECTOR AND EDGER GUIDE ASSEMBLY See Figures 5 and 6.
1.Remove the wing nut, flat washer, lock washer and bolt from the Owner’s Kit.
2.Place the grass deflector over the shaft and bracket.
3.Slide the assembled edger guide over the tabs on the grass deflector and bracket.
4.Place the bolt through the slots in the tabs on the grass deflector and trimmer.
NOTE: Ensure the slots are aligned before installing the bolt.
5.Install the flat washer, lock washer and wing nut.
6.Tighten the wing nut securely.
WING NUT
LOCK
WASHER
EDGER GUIDE
PIECES
FLAT WASHER
SHORT BOLT
Fig. 4
| TABS |
ASSEMBLED | Fig. 5 |
EDGER GUIDE | |
|
|
WING NUT |
|
LOCK
WASHER
LONG BOLT
FLAT
WASHER
Fig. 6
8
