Homelite F2035 manual Starting And Stopping, See Figures 12 and, To Start A Cold Engine, Operation

OPERATION

STARTING AND STOPPING

See Figures 12 and 13.

WARNING:

Never start or run the engine inside a closed or poorly ventilated area; breathing exhaust fumes can kill.

TO START A COLD ENGINE:

1.Lay trimmer on a flat, bare surface. Move switch to “I” (RUN) position.

NOTE: Unit is equipped with a positive on-off switch. Make sure switch is in the “I” (RUN) position before starting the unit.

2.Push primer bulb 8 to 10 times.

3.Set choke lever to choke position ( ).

4.Depress interlock, squeeze trigger and pull starter rope until engine tries to run. (No more than 6 pulls.)

5.Set choke lever to half choke position ( ).

6.Hold trigger and pull starter rope until engine runs.

7.Run engine 30 to 45 seconds at full throttle (with trigger depressed fully) on half choke position ( ) to warm up. Move choke lever to run position ( ).

TO START A WARM ENGINE:

1.Move choke lever to run position ( ).

2.Hold trigger and pull starter rope until engine runs.

TO STOP THE ENGINE:

To stop the engine, depress the switch to “O” position.

NOTE: Be sure to return the stop switch to the “I” (RUN) position before trying to start unit.

IGNITION SWITCH

I= ON TO RUN O = OFF TO STOP

THROTTLE INTERLOCK

THROTTLE

TRIGGER

Fig. 12

CHOKE LEVER

PRIMER BULB

RUN POSITION

HALF

CHOKE

POSITION

CHOKE

POSITION

Fig. 13

12