_CAUTION: | Before performing any service or adjustments: |
•Depress clutch/brake pedal fully and set parking brake.
Place gearshift lever in neutral (N) position.
Place attachment clutch in "DISENGAGED" position.
Turn ignition key "OFF" and remove key.
Make sure the blades and all moving parts have completely stopped.
•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plu_
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the right side of tractor.
•Place attachment clutch in =DISEN-
GAGED" position,
•Move attachment lift lever forward to lower mower to its lowest position.
•Roll belt off engine pulley,
•Remove small retainer spring, and lift clutch spring off pulley bolt.
•Remove large retainer spring, slide collar off and push housing guide out of bracket.
•Disconnect
•Disconnect suspension arms from rear deck brackets by removing retainer springs.
•Disconnect front links from deck by re- moving retainer springs.
•Raise lift lever to raise suspension
arms. Slide mower out from under trac- tor.
IMPORTANT: If an attachment other than the mower deck is to be mounted on the tractor, remove the front links and hook
the clutch spring onto square hole in frame.
TO INSTALL MOWER
•Raise attachment lift lever to its high- est position.
•Slide mower under tractor with dis- charge guard to right side of tractor.
•Lower lift lever to its lowest position.
•Install mower in reverse order of re- moval instructions.
TO LEVEL MOWER HOUSING
Adjust the'mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PROD-
UCT SPECIFICATIONS" on page 3 of this manual). If tires are over or underinflated, you will not properly adjust your mower.
Small Retainer Spring
';';""'% Square Hole
Suspension Arms
Engine Pulley
Retainer Spring |
|
|
|
|
|
|
| :TetainerSprings | |
Collar, |
|
|
| |
|
|
| (Both Sides) | |
|
| \ "1 | / | _, |
|
|
| / |
|
Housing | Large Retainer | Bracket |
|
|
|
|
| ||
|
|
|
| |
| Spring |
|
|
|
21
