The cutting height range is approxi- mately
of grass and types of grass being mowed.
•The average lawn should be cut to
approximately
during hot months. For healthier and better looking lawns, mow o_ten and after moderate growth.
•For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut
relatively high; the second to desired height.
•Lower mower with attachment lift control.
•Start mower blades by engaging attachment clutch control.
•TO STOP MOWER BLADES - disen- gage attachment clutch control.
CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield place.
Attachment Clutch Lever "Engaged"
Positiont Lift
Lever High
Position
":::_Low
Position
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper
position to help prevent scalping in most terrain conditions.
•Adjust gauge wheels with tractor on a flat level surface.
•Adjust mower to desired cutting height (See "TO ADJUST MOWER CUTTING HEIGHT" in the Operation section of this manual).
•With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole with shoulder bolt, 3/ 8 washer, and
•Repeat for opposite side installing gauge wheel in same adjustment hole.
| |
Locknut_ |
|
Gauge |
|
Wheel |
|
Mounting |
|
Bracket |
|
3/8 | ;houlder |
Gauge Wheet | Bolt |
|
TO OPERATE MOWER
Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.
•Select desired height of cut.
Position
Shield
TO OPERATE ON HILLS
_1_CAUTION: Do not drive up or down hills with slopes greater than 15 ° and do not drive across any slope.
•Choose the slowest speed before starting up or down hills.
•Avoid stopping or changing speed on hills.
•If slowing is necessary, move throttle control lever to slower position.
•If stopping is absolutely necessary, push clutch/brake pedal quickly to
brake position and engage parking brake.
•Move motion control lever to neutral
(N) position.
IMPORTANT: The motion control lever does not return to neutral (N) position when the clutch/brake pedal is de- pressed.
•To restart movement, slowly release parking brake and clutch/brake pedal.
•Slowly move motion control lever to slowest setting.
•Make all turns slowly.
TO TRANSPORT
When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheel-
ing position. Free wheel control is located at the rear drawbar of tractor.
•Raise attachment lift to highest position with attachment lift control.
14
