Craftsman 917.270962 owner manual Bottom edge, Both Front Links Should be Equal in Length, Nut F

Models: 917.270962

1 60
Download 60 pages 54.1 Kb
Page 23
Image 23

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PROD-

UCT SPECIFICATIONS" section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT

Raise mower to its highest position.

At the midpoint of both sides of mower, measure height from bottom edge of

mower to ground. Distance "A" on both sides of mower should be the

same or within 1/4" of each other.

If adjustment is necessary, make adjustment on one side of mower only.

To raise one side of mower, tighten lift link adjustment nut on that side.

To lower one side of mower, loosen lift

link adjustment nut on that side. NOTE:Each full turn of adjustment nut will change mower height about 1/8".

Recheck measurements after adjust- ing.

Bottom edge of

Bottom edge of

Before making any necessary adjust- ments, check that both front links are equal in length. Both links should be

approximately 10-3/8".

If links are not equal in length, adjust one link to same length as other link.

To lower front of mower loosen nut "E"

on both front links an equal number of turns.

°When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nuts "F" against trunnion on both front links.

°To raise front of mower, loosen nut "F" from trunnion on both front links.

Tighten nut "E" on both front links an

equal number of turns.

When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nut "F" against trunnion on both front links.

Recheck side-to-side adjustment.

Mandrel

m°w_Wer_grOund

Both Front Links Should be Equal in Length

Suspension

LiftLink Adjustment Nut

FRONT-TO-BACK ADJUSTMENT

IMPORTANT: Deck must be level side-to side. if the following front-to-back adjustment is necessary, be sure to adjust both front links equally so mower will stay level side-to-side.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in

its highest position.

Check adjustment on right side of tractor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.

"E"

Nut "F"_

Nut

Trunnion"_>

Front Links

23

Page 23
Image 23
Craftsman 917.270962 owner manual Bottom edge, Both Front Links Should be Equal in Length, LiftLink Adjustment Nut, Nut F