Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. Review the video cassette before you begin.
TOOLS REQUIRED FOR
ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes you need
are | listed | below. |
|
|
| |
(1) |
| 9/16" | wrench | (1) 3/4" | Socket w/ | |
(2) | 7/16" | wrenches | drive rachet | |||
|
|
| ||||
(2) |
| 1/2" wrench | (I) | Phillips Screw- | ||
(I) |
| Utility | knife | driver |
| |
|
|
|
| |||
(1)Pliers |
| (I) | Tire | pressure | ||
|
|
|
| gauge |
| |
When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating posi- tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
= Remove all accessible loose parts and parts boxes from shipping carton (See page 6)°
,Cut, from top to bottom, along lines on all four corners of shipping carton, and lay panels flat.
,Check for any additional loose parts or boxes and remove.
inside boot and onto adapter_
°Assemble large flat washer, 3/8 lock washer, 3/8 hex bolt and tighten securely.
•Snap steering wheel insert into center of steering wheel.
=Remove protective materials from trac- tor hood and grill.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires where tractor is to roll off skid.
Insert
_ | _S_/1_ | 3/8 Hex Belt |
| "_ | _3/8 Lockwasher |
',L... ___)
Whee!_Boot
Extension_ .,/Adapter
5/16
BEFORE ROLLING TRACTOR OFF SKID
ATTACH STEERING WHEEL
ASSEMBLE EXTENSION SHAFT AND BOOT
o Slide extension shaft onto lower steer-
ing shafL Align mounting holes in exten- sion and lower shafts and install 5/16
hex bolt and tocknut. Tighten securely. IMPORTANT: Tighten bolt and nut secure- ly to
Place tabs of steering boot over tab slots in dash and push down to secure.
INSTALL STEERING WHEEL
° Position front wheels of the tractor so they are pointing straight forward.
o Slide steering wheel adapter onto steer- ing shaft extension.
o Position steering wheel so cross bars are horizontal (left to right) and slide
Lower Steering..___ ,_,
i | # 3/ | t I |
TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)
•Press lift lever plunger and raise attach- ment lift lever to its highest position.
o Release parking brake by depressing clutch/brake pedal
°Place gearshift lever in neutral (N) posi- tion.
°Roll tractor forward off skid.
. Remove banding holding discharge guard up against tractor.
