TO REMOVE WHEEL FOR-REPAIRS
•Block up axle securely.
•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not
lose).
° Repair tire and reassemble.
,On rear wheels only: align grooves in rear wheel hub and axleo Insert square
key.
•Replace washers and snap retaining ring securely in axle groove.
o Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to stow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
Washers
Retaining Ring
Axle
TO START ENGINE THAT HAS A WEAK BATTERY
_kCAUTION:
ies. Always wear eye protection when around batteries.
If your battery is too weak to start the engine, it should be recharged, If "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: Your tractor is equipped with a 12 volt negative grounded system. The other vehicle must also be a 12 volt
negative grounded system. Do not use your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
°Connect each end of the RED cable to the POSITIVE (+) terminal of each bat-
tery, taking care not to short against chassis.
o Connect one end of the BLACK cable to the NEGATIVE
•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery,
TO REMOVE CABLES, REVERSE ORDER -
o Remove BLACK cable first from chassis
and then from the fully charged battery. o Remove RED cable last from both bat-
terieso
Positive Terminal | Negative Terminal |
Charged
BatteryNegative
PositiveTerminal
Terminal
TO REPLACE HEADLIGHT BULB
°Raise hood°
o Pull bulb holder out of the hole in the backside of the grill.
o Replace bulb in holder and push bulb holder securely back into the hole in the
backside of the grill. o Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or pre- vent it from starting.
o Check widng. See electrical wiring dia- gram in the Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp
TO REMOVE HOOD AND GRILL AS- SEMBLY
• Raise hood.
o Unsnap headlight wire connector.
°Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
°To replace, reverse above procedures.
N
Headlight Wire _ctor
25