TO LEVEL MOWER HOUSING
Adjust the mower while tremor is parked on level ground or driveway. Make sure tires are properly inflated (See "PROD- UCT SPECIFICATIONS" section of this
manual). If tires are overor undednflated, you will not properly adjust
your mower.
•Raise mower to its highest position.
•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance "A"on both aides of mower should be the same or within 1/4" of each other.
•If adjustment is necessary, make adjustment on one side of mower only.
•To raise one side of mower, tighten llft link adjustment nut on that side,
•To lower one side of mower, loosen lift
link adjustment nut on that side• NOTE: Each full turn of adjustment nut will change mower height about 1/8".
•Recheck measurements after adjust- ing.
Bottom edgeof | Bottomedgeof |
•Before making any necessary adjust- ments, check that both front links are equal in length.
•If finks are not equal in length, adjust one link to same length as other link.
•To lower front of mower loosen nut "E" on both front links an equal number of turns.
•When distance "D" is 1/8"to 1/2" lower at front than rear, tighten nuts "F" against trunnion on both front links.
•To raise front of mower, loosen nut "F" from trunnion on both front links, Tighten nut "E" on both front links an equal number of turns.
•When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nut "F" against trunnion on both front links.
•Recheck
,,_",Mandrel
._%\\ I. °°1_
Both Front Links Should be Equal in Length
gm°Wnet mgr°Wo'nt
n Arm
Lift Link
Adjustment Nut
adjust both front links equally so mower
will stay level
To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in
its highest position.
Check adjustment on right side of tractor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.
Nut "_
Trunnion_
Front Links
23
