Craftsman 917.27207 To Adjust Gauge Wheels, To Operate Mower, To Operate On Rills, To Transport

•The average lawn should be cut to approximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth.

•For best cutting performance, grass over 6 inches in height should be mowed twice• Make the first cut

relatively high; the second to desired height.

TO ADJUST GAUGE WHEELS

Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position• Gauge wheels then keep the deck in proper

position to help prevent scalping in most terrain conditions.

NOTE: Adjust gauge wheels with tractor on a flat level surface.

1.Adjust mower to desired cutting height (See "TO ADJUST MOWER CUTTING HEIGHT" in the Operation section of

this manual)•

2• With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground• Install gauge wheel in appropriate hole with shoulder belt, 3/ 8 washer, and 3/8-16 Iocknut and tighten securely•

3.Repeat for opposite side installing

gauge wheel in same adjustment hole.

Mountir

Locknut

Gauge Wheel

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch• Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine• 1. Select desired height of cut.

2_ Start mower blades by engaging attachment clutch control•

TO STOP MOWER BLADES - disengage attachment clutch control

_CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector

shield in place•
Attachment
Clutch Lever				Attachemnt
E gaged	__		_Lift		Lever High
Position	__"_'_		_	Position
._			l		Position
'Disengaged		I	' :	,,!
Position	:	i
			'	_	Deflector
				IJ	Shield
TO OPERATE		ON RILLS

,_CAUTION: Do not drive up or down hills with slopes greater than 15 ° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills•

•Avoid stopping or changing speed on hi_ls.

•If slowing is necessary, move throttle control lever to slower position•

•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.

•Move gearshift lever to 1st gear• Be sure you have allowed room for tractor to roll slightly as you restart movement•

•To restart movement, slowly release parking brake and clutch/brake pedal.

•Make all turns slowly.

TO TRANSPORT

•Raise attachment lift to highest position with attachment lift control.

•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position•

•Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor• Use an appropriate means of tying hood to tractor (rope, cord, etc.).

14