TO REPLACE MOWER BLADE DRIVE BELT
The mower blade drive belt may be
replaced without tools. Park the tractor on level surface. Engage parking brake.
BELT REMOVAL -
1, Remove mower from tractor (See "TO
REMOVE MOWER" in this section of this manual).
2.Work belt off both mandrel pulleys and idler purleys.
3.Pull belt away from mower.
BELT INSTALLATION -
4.Install new belt in reverse order of removal.
5.Make sure belt is in all pulley grooves and inside all belt guides.
6.Install mower in reverse order of removal instructions.
Mandrel |
|
Pulley _ | Idler Pulleys |
Mandrel
Pulley
TO ADJUST BRAKE
Your tractor is equipped with an adjust- able brake system which is mounted on the right side of the transaxre.
If tractor requires more than six (6) feet stopping distance at high speed in highest gear on a level dry concrete or paved surface, then brake must be adjusted.
1.Depress clutch/brake pedal and engage parking brake.
2.Measure distance between brake
operating arm and nut "A" on brake rod.
3.If distance is other than
4.Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still greater than six (6) feet in highest gear, further maintenance is neces- sary. Contact a Sears or other qualified service center.
With Parking Brake "Engaged"
Nut "A"
Jam Nut
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage parking brake. For assistance, there is a
belt installation guide decal on bottom side of left footrest.
1.Remove mower (See "TO REMOVE MOWER" in this section of this
manual.)
2.Remove belt from stationary idler and clutching idler.
3.Pull belt slack toward rear of tractor. Remove belt upwards from transaxle pulley by deflecting belt keepers.
4.Pull belt toward front of tractor and remove downwards from around engine pulley.
5.Install new belt by reversing above procedure.
Engine
Idler
Id{er
/
Transaxle_.
23
